Table of Contents
Advertisement
4.4.3.3 Sensors
This page is where the Sensor Parameters are defined. Reading 1 is for Temperature,
Reading 2 is for Humidity, and Reading 3 is for Dewpoint.
Sensors
Address
http://192.168.1.200
Readings
Date and Time
Overview
Description
Network
End Character 0x
Configuration
Management
Security
Recording
System
Diagnostics
Description
Log Out
End Character 0x
Description
End Character 0x
Description – This can be a name for the sensor or where the sensor is located. This
field is text only and can have up to 16 alphanumeric characters. This description will
appear wherever Reading 1, 2 or 3 is displayed on the web server.
Unit – This is the unit of measurement for temperature. It can be either C for Celsius or F
for Fahrenheit.
Once the unit is selected, either C or F, it will be a global change throughout the
web server, as well as on the LCD display. If you use the front C/F buttons to
change the unit of temperature it will have no affect on the web pages.
Display – If checked the variable (i.e. Temperature1) will be displayed on the Readings
and Chart applets as well as data transmission in Continuous mode (see Server Type
Section 4.4.3.2). The default is checked.
Web Link
Server
Sensors
Reading 1
Temperature 1
0D
Adjust by
Offset
Reading 2
Humidity
0D
Adjust by
Offset
Reading 3
Dewpoint
0D
Samplng Rate
Figure 4.17 Configuration Menu: Sensors
Setup
Contact Closures
Unit
C
Data Format
Offset
0.0
Reading Low 0.0
Reading High 100.0
Unit
%
Data Format H00.0%
Offset
0.0
Reading Low 0.0
Reading High 100.0
Unit
C
Data Format D000.0C
One Sample per
Save Changes
26
Alarm Relays
Display
T000.0C
Ref. Low 0.0
Ref. High 100.0
Display
Ref. Low 0.0
Ref. High 100.0
Display
10 seconds
Reset
Advertisement
Table of Contents
