Installing The Embroidery Frame Holder - Brother 884-T13 Operation Manual

Installing the embroidery frame
holder
After embroidering using the cap embroidery
frame is finished, remove the needle plate spacer
and cap frame driver, and then re-attach the
embroidery frame holder.
a Remove the needle plate spacer.
1 Needle plate spacer
b Loosen the two lower thumb screws.
1 Thumb screws
c Remove the two upper thumb screws.
1 Thumb screws
276
d Remove the cap frame driver.
Note
• Be careful that the cap frame driver does
not hit any nearby parts, such as the
presser foot.
e With the hole on the sweat guard holder
aligned with the centerline of the guiding
plate, insert the two thumb screws removed
c
in step into the holes at the top, and then
tighten the thumb screws.
1 Hole on the sweat guard holder
2 Centerline of guiding plate
3 Holes on the top
• Insert the thumb screws into the holes where the cap
frame driver that was originally installed (holes that
the thumb screws were removed from in step
page 265).
→ The movable section of the cap frame driver is
secured.
b
on