Table of Contents
Advertisement
The needle bar case has stopped at an
incorrect position.
Touch
to automatically reset the
needle bar case.
Another operation was performed
while the automatic needle-threading
mechanism was threading the needle.
Press the automatic needle threading
button, and then perform the other
operation after the needle is threaded.
(Refer to page 61.)
The memory capacity of the USB media
has been exceeded.
There is too much data in either the
machine or the USB media.
The needle bar case motor has locked
up.
Touch
to automatically reset the
needle bar case.
Too many patterns are being combined
for the amount of memory available.
Delete some patterns from the
combined pattern.
was touched in the
embroidering screen.
Touch
to return to the
embroidering settings screen. The
previous embroidery in the
embroidering screen will be canceled.
APPENDIX
The automatic needle-threading
mechanism did not operate correctly.
Remove the thread entangled in the
automatic needle-threading
mechanism, and then touch
The pattern could not be saved because
the memory is full.
Delete some patterns.
The selected pattern is going to be
deleted because
was touched.
.
7
301
Advertisement
Table of Contents
Troubleshooting
