Brother 884-T13 Operation Manual page 210

1 Touch the connecting area
2 Second pattern B
3 First pattern A
4 Touch to move the second pattern.
Press to rotate the second pattern in a
clockwise arc referring the first pattern as a
center.
Press to rotate the second pattern in a
counterclockwise arc referring the first
pattern as a center.
Press to rotate the second pattern 90
degrees in a clockwise arc.
→ Message appears on screen and carriage will move
after pressing
Note
• The second pattern will be automatically
connected to the first pattern without
adjustment. Change the position of the
second pattern manually using
• The position of the second pattern can be
moved using your finger or the included
touch pen.
• Use , or
the pattern to the corner of the center of the
first pattern, when changing the pattern's
connecting position.
208
3
1
2
4
.
.
if you want to align
j Prepare two embroidery positioning
stickers. We will follow the on-screen
instructions to affix these two stickers to the
fabric so that the positioning marks can be
detected by the camera.
Note
• Use the positioning stickers included with
this product or purchase replacement
stickers (SAEPS2, EPS2: XF0763-001) from
your Brother dealer. If any other sticker is
used, the camera may not recognize it.
• The 182 mm × 257 mm (7 inches × 10
inches) embroidery positioning sticker sheet
with strong adhesive is most appropriate for
connecting patterns (SAEPS2, EPS2:
XF0763-001). If any other positioning sticker
is used, it may peel off. If the sticker peels
off, the patterns cannot be connected.
k Affix the first embroidery positioning
sticker onto the fabric within the red lines
by using both hands to press down on each
corner of the sticker. Affix the sticker with
the large circle to the top as shown on
machine. Then, touch
→ The camera detects the first positioning sticker.
.