Table of Contents
Advertisement
Note
• Loosen the two screws for the outside
clamping frame, and then adjust the
position of the outside clamping frame so
that it conforms to the shape of the cap and
so that the teeth of the clamping frame
perfectly align with the base of the brim.
1 Teeth of outside clamping frame
2 Base of brim
3 Outside clamping frame
4 Screws for the outside clamping frame
k
Secure the clamping frame with the snap
lock. At this time, push the end of the sweat
guard into the cap so it does not interfere
with the snap lock.
1 Snap lock
2 Fold the sweat guard as shown.
Note
• Before closing the lever of the snap lock,
check that the cap has not moved out of
position and that there are no wrinkles.
Adjust the cap if necessary.
272
l
Close the lever of the snap lock.
1 Lever of the snap lock
Note
• If the cap fabric is thick and the clamping
frame cannot be closed, or if the fabric is
thin and the cap is too loose within the
frame, loosen the screw for the inside
clamping frame, and then adjust the inside
clamping frame.
1 Inside clamping frame
2 Screw for the inside clamping frame
m
Pull the brim holder up as far as possible,
flipping the holder over the cap brim then
pushing down on the holder to secure the
brim.
1 Brim holder
2 Center line of brim holder
• Make sure the notch comes out.
Advertisement
Table of Contents
Troubleshooting
