Table of Contents
Advertisement
b
Attach the cap frame to the cap frame
driver.
Turn the cap frame to the left so the brim of the cap
does not hit the embroidery machine. Do not insert the
cap frame with the brim pointing to the right,
otherwise parts of the cap frame may hit the
embroidery machine.
• Be careful that the cap frame does not hit any nearby
parts, such as the presser foot.
After turning the cap frame so that the front of the cap
faces upward, align the ring of the cap frame with the
ring of the cap frame driver. While sliding the cap
frame to the left and right, align the notch in the cap
frame with the guiding plate on the cap frame driver,
and then snap the frame into place.
1 Guiding plate on cap frame driver
2 Notch on cap frame
3 Holder
→ The cap frame is secured with holders. Make sure
that all of the holders on the driver are firmly
secured in the frame holes. This completes the
installation of the cap frame, and the cap is ready to
be embroidered.
■ Removing the cap frame
After embroidering is finished, remove the cap
frame, and then remove the cap.
a
Remove the cap frame from the cap frame
driver.
Place both thumbs on the cap frame holders, grasping
the handles on both the right and left side, gently
pulling toward you. As shown in the illustration.
1 Holder
2 Handle
Before removing the cap frame, turn it to the left so
that the brim of the cap does not hit the embroidery
machine.
• Be careful that the cap frame does not hit any nearby
parts, such as the presser foot.
b
After removing the brim holder, unlock the
snap lock of the clamping frame, remove
the clips, and then remove the cap.
1 Brim holder
2 Snap lock
3 Clips
APPENDIX
7
275
Advertisement
Table of Contents
Troubleshooting
