Installing The Embroidery Frame Holder - Brother Entrepreneur Pro PR1000e Operation Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Installing the embroidery
frame holder
After embroidering using the cap embroidery frame
is finished, remove the needle plate spacer and cap
frame driver, and then re-attach the embroidery
frame holder.
1 Remove the needle plate spacer.
1 Needle plate spacer
2 Loosen the two lower thumb screws.
1 Thumb screws
3 Remove the two upper thumb screws
1 Thumb screws
274
4 Remove the cap frame driver.
Note
● Be careful that the cap frame driver does
not hit any nearby parts, such as the
presser foot.
5 With the hole on the sweat guard holder
aligned with the centerline of the guiding
plate, insert the two thumb screws removed
3
in step into the holes at the top, and then
tighten the thumb screws.
1 Hole on the sweat guard holder
2 Centerline of guiding plate
3 Holes on the top
• Insert the thumb screws into the holes
where the cap frame driver that was
originally installed (holes that the thumb
screws were removed from in step
page 261).
The movable section of the cap frame
driver is secured.
2
on