Installing The Embroidery Frame Holder - Brother PR-620 Operation Manual

■ For the advanced cap frame
2 After removing the brim holder, unlock the
snap lock of the cap frame, remove the clips,
and then remove the cap.
3
1 Brim holder
2 Snap lock
3 Clips
Installing the embroidery
frame holder
After embroidering using the cap embroidery frame
is finished, remove the needle plate spacer and cap
frame driver, and then re-attach the embroidery
frame holder.
1 Remove the needle plate spacer.
1 Needle plate spacer
2 Loosen the two lower thumb screws.
1 Thumb screws
3
1
2
4
5
Remove the two upper thumb screws
1 Thumb screws
Remove the cap frame driver.
Note
● Be careful that the cap frame driver does not
hit any nearby parts, such as the presser
foot.
With the hole on the sweat guard holder
aligned with the centerline of the guiding
plate, insert the two thumb screws removed in
3
step into the holes at the top, and then
tighten the thumb screws.
3
1 Hole on the sweat guard holder
2 Centerline of guiding plate
3 Holes on the top
• Insert the thumb screws into the holes where
the cap frame driver that was originally
installed (holes that the thumb screws were
2
removed from in step
The movable section of the cap frame driver
is secured.
Using the Optional Cap Frame
1
3
1
2
on page 171).
185
7