Ricoh B230 Service Manual page 1032

Bit Switches
5-6 Not Used
Image Resolution of RX Text Mail
This setting determines the image resolution of the received mail.
0: 200 x 200
7
1: 400 x 400
The "1" setting requires installation of the Function Upgrade Card in order to have
enough SAF (Store and Forward) memory to receive images at 400 x 400
resolution.
I-fax Switch 03 - Not used (do not change the settings) [ SP No. 1-102-004]
I-fax Switch 04 [SP No. 1-102-005]
No FUNCTION
Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the
RTI/CSI of the originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the
0
RTI or CSI is used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the
Subject line that indicates where the transmission originated can be used to
determine automatically the destination folder for each e-mail.
Subject corresponding to mail post database
0: Standard subject
1: Mail post database subject
The standard subject is replaced by the mail post database subject in the following
three cases:
1) When the service technician sets the service (software) switch.
2) When memory sending, delivery specified by F code or SMTP reception is
1
done.
3) With relay broadcasting (1st stage without the Schmidt 4 function).
This switch does not apply for condition 3) when the RX system is set up
for
when operators are using FOL (to prevent problems when receiving
transmissions).
2-7 Not Used
I-fax Switch 05 [SP No. 1-102-006]
No FUNCTION
0 Mail Addresses of SMTP Broadcast Recipients
B786
memory sending, delivery by F-code, sending with SMTP RX and
COMMENTS
COMMENTS
60 SM