Ricoh B230 Service Manual page 1022

Bit Switches
Always enabled
System Switch 03 [SP No. 1-101-004]
No FUNCTION
Length of time that RDS is
temporarily switched on when
0-7
bits 6 and 7 of System Switch
02 are set to "User selectable"
System Switch 04 [SP No. 1-101-005]
No FUNCTION
0-2 Not used
Printing dedicated tx
parameters on Quick/Speed
3 Dial Lists
0: Disabled
1: Enabled
4-7 Not used
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 [SP No. 1-101-010]
No FUNCTION
Addition of image data from
confidential transmissions on
0
the transmission result report
0: Disabled 1: Enabled
Inclusion of communications
on the Journal when no image
1
data was exchanged.
0: Disabled 1: Enabled
B786
(1,1): At any time, an RDS system can access the
machine.
COMMENTS
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
COMMENTS
Do not change these settings.
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters.
Do not change these settings.
COMMENTS
If this feature is enabled, the top half of the first
page of confidential messages will be printed on
transmission result reports.
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed on
the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
50 SM