Ricoh B230 Service Manual page 1027

System Switch 17 - Not used (do not change these settings)
System Switch 18 - Not used (do not change these settings)
System Switch 19 [SP No. 1-101-026]
No FUNCTION
0-5 Not used
Extended scanner page
memory after memory option
6 is installed
0: Disabled
1: Enabled
Special Original mode
7 0: Disabled
1: Enabled
System Switch 1A [SP No. 1-101-027]
No. FUNCTION
LS RX memory remaining
0-7
refresh value setting
System Switch 1B - Not used (do not change these settings)
System Switch 1C - Not used (do not change these settings)
System Switch 1D [SP No. 1-101-030]
No FUNCTION
RTI/CSI/CPS code display
0 0: Enable
1: Disable
1 Not used
SM
COMMENTS
Do not change the settings.
0: After installing the memory expansion option, the
scanner page memory is extended to 4 MB from 2
MB.
1: If this bit is set to 1 after installing the memory
expansion option, the scanner page memory is
extended to 12 MB. But the SAF memory
decreases to 18 MB.
1: If the customer frequently wishes to transmit a
form or letterhead which has a colored or printed
background, change this bit to "1". "Original 1" and
"Original 2" can be selected in addition to the
"Text", "Text/Photo" and "Photo" modes.
COMMENTS
Sets a value of 4K.
If the amount of memory remaining falls below 4K,
documents received in memory are printed to
create more space in memory.
Initial value: 0x80 (512K)
00-FF (0-1020 KB: Hex)
COMMENTS
0: RTI, CSI, CPS codes are displayed on the top
line of the LCD panel during communication.
1: Codes are switched off (no display)
Do not change this setting.
55
Bit Switches
B786