Ricoh B230 Service Manual page 1002

Error Codes
Code Meaning
15-92 Memory Overflow
15-93 Memory Access Error
15-94 Incorrect ID Code
15-95 Transfer Station Function
22-00 Original length exceeded
the maximum scan length
22-01 Memory overflow while
receiving
22-02 Tx or rx job stalled due to
line disconnection at the
other end
22-04 The machine cannot store
received data in the SAF
22-05 No G3 parameter
confirmation answer
23-00 Data read timeout during
construction
25-00 The machine software
resets itself after a fatal
transmission error
occurred
B786
Suggested Cause/Action
transfer destination is incorrect.
Destinations are full so the final and transfer
destinations could not be created.
Transmission could not be received because
memory overflowed during the transaction.
Transaction could not complete due to a
malfunction of SAF memory.
The machine rejected an incoming e-mail for
transfer request, because the ID code in the
incoming e-mail did not match the ID code
registered in the machine.
The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
Divide the original into more than one page.
Check the resolution used for scanning.
Lower the scan resolution if possible.
Add optional page memory.
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to an
another fax machine, if the machine's printer
is busy or out of order.
Add an optional SAF memory card or hard
disk.
The job started normally but did not finish
normally; data may or may not have been
received fully.
Restart the machine.
Update the ROM
Replace the FCU.
Defective FCU board or firmware.
Restart the machine.
Replace the FCU.
Update the ROM
Replace the FCU.
30
Rev. 10/09/2009
SM