I-Fax Switches - Ricoh B230 Service Manual

the sender has an RTI or CSI
5-7 Not used
System Switch 1F [SP No. 1-101-032]
No FUNCTION
0 Not used
Report printout after an
original jam during SAF
storage or if the SAF memory
1
fills up
0: Enabled
1: Disabled
2 Not used
Received fax print start timing
(G3 reception)
3
0: After receiving each page
1: After receiving all pages
4-6 Not used
Action when a fax SC has
occurred
7
0: Automatic reset
1: Fax unit stops

4.3.2 I-FAX SWITCHES

I-fax Switch 00 [SP No. 1-102-001]
FUNCTION
No
Original Width of TX
Attachment File
0 A4
1 B4
2 A3
SM
block messages from senders that do not include
an RTI or CSI, change this bit to "1", then enable
Authorized Reception.
Otherwise, keep this bit at "0 (default setting)".
Do not change the settings
COMMENTS
Do not change the settings.
0: When an original jams, or the SAF memory
overflows during scanning, a report will be printed.
Change this bit to "1" if the customer does not
want to have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
Do not change the settings.
0: The machine prints each page immediately
after the machine receives it.
1: The machine prints the complete message after
the machine receives all the pages in the memory.
Do not change the factory settings.
0: When the fax unit detects a fax SC code other
than SC1201 and SC1207, the fax unit
automatically resets itself.
1: When the fax unit detects any fax SC code, the
fax unit stops.
Cross Reference
Fax SC codes - See "Troubleshooting"
COMMENTS
This setting sets the maximum size of the original
that the destination can receive. (Bits 3~7 are
reserved for future use or not used.)
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to "1",
the larger size has priority. For example, if both Bit
2 and Bit 1 are set to "1" then the maximum size
57
Bit Switches
B786