Valve And Valve Spring - Remove; Nozzle Gland Stud Bolt And Bridge Guide - Remove - Mitsubishi S6R Series Service Manual

1.11 Valve and Valve Spring - Remove

Using a valve spring pusher, compress the valve spring
evenly and remove the valve cotters.
Note: If valves are reusable, mark each valve seat and the
mating valve to identify their original positions. Do not
change the combination of the valve seat and the valve
when reassembling.

1.12 Nozzle Gland Stud Bolt and Bridge Guide - Remove

Do not remove the nozzle gland stud bolt and the bridge
guide from the cylinder head, unless they are defective.
If they are removed, see "Nozzle Gland Stud Bolt and
Bridge Guide - Inspect and Replace" of "INSPECTION
AND REPAIR OF BASIC ENGINE."
Chapter 5 DISASSEMBLY OF BASIC ENGINE
Valve Spring - Compress
Valve rotator
Inner valve spring
Outer valve spring
Lower retainer
Exhaust
double spring type
Exhaust side
Valve and Valve Spring - Remove
Bridge guide
Nozzle Gland Stud Bolt and Bridge Guide -
Remove
Valve spring pusher
P/N:33591-04500
Valve cotter
Valve rotator
Valve spring
Stem seal
Inlet side
Nozzle gland stud bolt
Bridge guide
5-7