Mitsubishi S6R Series Service Manual page 241

2.8.1 Oil Seal - Install
(1) Tap-in the oil seal with installer making sure that oil
seal surface is flush with water pump housing face.
(2) Apply engine oil to the oil seal lip.
2.8.2 Water Pump Bearings - Install
Install the bearing to water pump shaft. Orient each bearing
so that its shield plate faces to oil seal side when installing
the bearing to shaft.
2.8.3 Unit Seal (Stationary Side) - Install
(1) Apply sealant (ThreeBond 1102) to the outer circum-
ference of unit seal (stationary side.)
(2) Tap-in the unit seal into water pump case with unit seal
installer.
2.8.4 Water Pump Shaft - Install
Be careful not to damage the water pump shaft by oil
seal and unit seal (fixing side) when press-fitting the
water pump shaft.
(1) Press-in the water pump shaft slowly into pump case
until the end of ball bearing comes into contact with
pump case.
(2) Securely install the snap ring to groove.
Chapter 10 COOLING SYSTEM
Impeller side
Make it flush.
Application of
engine oil
Case
Oil Seal - Install
Shield plate
Bearing
Water Pump Bearings - Install
Unit seal
Application
of sealant
Unit Seal (Stationary Side) - Install
Water Pump Shaft - Install
Installer
Oil seal
Bearing
Water pump shaft
Apply ThreeBond
1102 to outer
circumference.
Water pump
case
Snap ring
Water pump shaft
10-17