Coupling - Remove; Damper Face And Radial Runout - Measure - Mitsubishi S6R Series Service Manual

Chapter 5 DISASSEMBLY OF BASIC ENGINE

3.1 Coupling - Remove

(With tachometer spec)
(1) Remove the oil seal case and oil seal from the crank-
case or fan drive case.
Note: Replace the removed oil seal with a new one. Oil seal
can not be re-used.
(2) Screw two jack bolts evenly into the jack bolt holes,
and remove the coupling from the camshaft.

3.2 Damper Face and Radial Runout - Measure

Measure the face and radial runout of the damper, and know
the current condition.
For the measurement procedure, refer to "Damper Face and
Radial Runout - Measure" of "ASSEMBLY OF BASIC
ENGINE."
5-14
Oil seal case
Oil seal
O-ring
Oil Seal Case - Remove
Jack bolt
(M12×1.25 mm)
Coupling - Remove
Face runout
Radial runout
Damper Face and Radial Runout - Measure