Lubrication System - Install; Oil Pump - Install; Oil Pan - Install - Mitsubishi S6R Series Service Manual

Chapter 9 LUBRICATION SYSTEM

3. Lubrication System - Install

Install the parts in the reverse order of the disassemble sequence. (Refer to the illustration for disassembling.)
Thoroughly clean and dry the oil passage.

3.1 Oil Pump - Install

After installing the oil pump to crankcase, measure the
backlash of crankshaft gear and oil pump gear.
If the backlash is out of the standard, insert shims to oil
pump mounting portion to adjust the backlash.
Item
Backlash between oil pump gear
and crankshaft gear

3.2 Oil Pan - Install

(1) Apply sealant (Heldite) to four places on both surfaces
of oil pan packing joints, and attach the packing to the
oil pan.
(2) Install two guide bolts into the crankcase, and install
the oil pan.
(3) Tighten the mounting bolts to the specified torque.
9-20
Standard value
0.11 to 0.38 mm
[0.0043 to 0.0150 in.]
Oil pipe
Oil strainer
108 ± 10.8 N·m
{11 ± 1.1 kgf·m}
[80 ± 8.0 lbf·ft]
Backlash When Installing Oil Pump - Adjust
59 ± 5.9 N·m
{6 ± 0.6 kgf·m} [43.5 ± 4.35 lbf·ft]
Oil Pan - Install
Shim t = 0.1 mm [0.004 in.]
P/N:37535-01100
Oil pump gear
Joints, 4 places