Common Errors - Paxar Monarch 9825 Quick Reference

C o m m o n E r r o r s
Error Description/Action
002 Name must be 1 to 8 characters inside quotes.
005 Supply width is invalid.
018 Code page selection defined in the field is invalid.
025 Data length is too long.
101 Format referenced by batch not in memory.
400 Invalid character following {.
403 Field separator was not found.
409 Printer memory is full. Delete unnecessary formats or graphics from memory.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.
413 Online receive buffer is full. Check for a flow control problem.
611 Font, bar code, or density in the batch does not fit the format.
612 The data in this line of the batch is either missing or does not match the format.
613 Reference point off supply.
614 Portion of field off supply or there may be an invalid character in the packet.
703 The printer sensed a calibration of different-sized black marks. Make sure the
correct supply type is loaded.
704 Printer has not sensed a supply mark when expected or is out of supplies.
Press Escape/Clear and try to continue printing. Change supply.
751 Printer did not sense a black mark when expected. Press Escape/Clear and try
to continue printing. Change supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Check for a ribbon jam or remove any slack in the ribbon by turning the take-up
reel clockwise. Load a new ribbon.
755 Printhead is open. Close the printhead.
756 Load supplies.
757 Load supplies (supply length mismatch). Press Feed/Cut.
758 Either the supply is not seen, the on-demand sensor is broken, or a label was
removed too quickly. Check for a label jam or reload supplies.
763 Waiting to dispense label. Press Feed/Cut.
765 The printhead has less than 8 bad dots and can shift bar code fields to avoid
bad dots. Press Escape/Clear to continue printing.
768 Printhead has more than 30 bad dots or is not connected. Connect the
printhead.
11