Paxar Monarch 9825 Quick Reference page 4

Adjust the supply holder guides so the sides barely touch the roll. Make sure
5.
the supply roll turns freely. If you are using fan-fold supplies, place the
supply stack behind the printer, label side facing up.
Push down on the supply lever to unlock the supply guides.
6.
Lay the label strip across the supply guide so that a few inches extend past the
7.
front of the printer. Tuck the supply under the nibs and in between the die cut
sensor.
For fan-fold supplies, lay the label strip over the supply holder and
across the supply guide so that a few inches extend past the front of the
printer. Tuck the supply under the nibs and in between the die cut sensor.
Adjust the supply guides so they touch the supply. Push up on the supply lever
8.
to lock the supply guides into place.
4
Supply
Holder
Guides
D i e C u t S e n s o r
Nibs
Supply
Lever