Paxar 9402 Reference Manual page 51

Command
Resets the printer. This command takes five seconds to complete and then
^PR
the printer is ready to receive data. It has the same effect as turning off
and then turning on the printer.
NOTE: Command should be used only when the printer is not printing.
Repeats the last printed batch, printing the same number of labels as
^RB
specified in the original batch. This command does not work if using batch
separators.
NOTE: Printer ignores this command if printing.
Resynchronizes supply when supply roll is changed.
^RS
NOTE: Printer ignores this command if printing.
Disables the status polling feature by turning off the status polling control
^SD or
character. Sets the status polling control character to the ASCII value
^SCd
given by the d parameter. The value of d can be any ASCII character.
Loads script with host response (9825/985x/9860)
^SFa
Loads script without host response (9825/985x/9860).
^SFb
Enables script (9825/985x/9860).
^SFc
Disables script (9825/985x/9860).
^SFd
Uploads script version information (9825/985x/9860).
^SFe
Deletes script (9825/985x/9860).
^SFf
Turns on ENQ status polling before it reaches the script (9825/985x/9860).
^SFg
Turns off ENQ status polling before it reaches the script (9825/985x/9860).
^SFh
Turns on immediate commands before it reaches the script
^SFi
(9825/985x/9860).
Turns off immediate commands before it reaches the script
^SFj
(9825/985x/9860).
Prints a test label set. NOTE: Printer ignores this command if printing.
^TP
The table represents the defined immediate command control
character as ^ and the defined status polling control character as
d. You may define these characters to suit your needs.
To use the immediate command control
character or the status polling character
within your data, use the tilde sequence.
Parameter
Configuring the Printer 2-31