Volvo Penta AQUAMATIC 280 Workshop Manual page 86

5. Should the shift fork require replacement, remove
the cotter pin (1). Remove the shaft (2) and remove
the shift yoke (3). To install reverse procedure.
NOTE! Always use a new cotter pin when reinstall-
ing.
6. Remove the bearing race of the axial bearing. Use
special tool 884140 and 884143. Also replace the O-
rings (1). One on each side of the oil tube.
7. Grease the lower hook up fork bushing with Volvo
Penta part np. 828250-1 water resistant grease. Using
special tool 884259 and 9991801, press in the bush-
ing.
8. Press the bushing into the hook up fork. Use spe-
cial tools 884259 with handle 9991801.
Repair instructions
9991801
884259
9991801
884259
83