Volvo Penta AQUAMATIC 280 Workshop Manual page 146

Trim cylinders, all models
6. Install a grease nipple where the ground terminal
bushing (late models) or plastic plug (early models)
was removed.
Use grease nipple, Volvo Penta part no. 940194.
7. Remove the locking bolt for the trim cylinder dowel
pin. Key width 10 mm.
Part no.
940194
8. Use a grease gun and inject grease into the grease
nipple. The dowel pin will then be pushed out and the
trim cylinder can be removed.
9. If the dowel pin will not come out by using a grease
gun, special tool 884978 should be used as follows:
Remove the grease fitting.
Fill the tool with grease.
Screw the tool into the transom shield and carefully
tighten.
Unscrew the locking trim cylinder pin locking bolt (1)
approx. 10 mm (¼").
Hit the tool piston (2) with a hammer so that the trim
cylinder pin is forced against the locking bolt.
Unscrew the locking bolt completely. Force the pin the
rest of the way out of the hole.
Transom shield
884978
1
2
143