Volvo Penta AQUAMATIC 280 Workshop Manual page 103

Repair instructions
7. Remove the two Allen-head screws from the propel-
ler bearing housing. Key width:
884789
884161
8. Install special tool 884789 on the outer propeller
shaft. Using special tool 884161 with a slide ham-
mer, remove the outer propeller shaft and bearing
housing.
9. Remove the 2 O-rings (1) from the propeller shaft
housing. Discard the O-rings.
100
3 / ".
8
1
10. Install special tool 885197 on the inner propeller
shaft.
884802
11. Install special tool 884802 over the inner propeller
shaft. Add the washer and nut from tool 885197. The
slot in the end of the tool should face the pinion gear.
Tighten the nut until the shaft is extracted from the
forward gear. Use a 30 mm wrench.
885143
12. Brace special tool 884830 in a vise and place the
lower unit upside down in the tool.