Volvo Penta AQUAMATIC 280 Workshop Manual page 35

Repair instructions
9. Lift out the upper gear and the bearing box as well
as the engagement sleeve.
10. Lift off the upper gear housing from the special
tool. Dismantle the lower gear set and the shaft by re-
moving the split locking ring (1) and the washer (2).
Mark the gears to ensure the same location when as-
sembling.
NOTE! Handle the engagement sleeve and gear wheel
cones with utmost care to avoid scratching them.
32
11. Remove the needle bearings (1) and the spacer
rings (2) from the upper and lower gear sets.
NOTE! The needle bearings are matched in pairs and
must not be mixed!
1
2
12. Remove by pressing out the upper and lower of
the bearing sleeves. Use special tools 884386 and
884259.
1
884259
884386
2