Volvo Penta AQUAMATIC 280 Workshop Manual page 84

15. Insert the wear washer (1) between the steering
yoke and the intermediate housing and push in the
steering spindle until the collar bottoms.
16. Install the hose connection and the gasket on the
yoke. Coat the surfaces with sealing compound,
Volvo Penta part no. 1161099-5 or Permatex
17. If the trim cylinder attachment is in need of repair
or in need of being replaced, remove the 2 collar
screws. Use a socket wrench (17 mm) as a counter
hold. Then install the new cylinder attachment.
NOTE! Use the same screws, washers and nuts un-
less they are damaged.
18. Install the shift yoke (3) and push in the shaft (2)
and lock it with the cotter pin (1).
®
no. 3.
NOTE! Install a washer on each side of the cotter
pin!
Repair instructions
81