Volvo Penta AQUAMATIC 280 Workshop Manual page 110

884263
6. Use special tool 884263 to press the gear and bear-
ing assembly onto the propeller shaft. Use special tool
884799 to protect the bearing.
WARNING! Do not press on by using the
bearing race!
Shimming the vertical shaft
7. Grease the bearing location. Carefully align the nee-
dle bearing when installing it in the gear housing.
Use special tool 884792 in combination with 884241.
Turn the bearing to allow the tool 884792 to press
against the text on the bearing. Tighten the screw
until the bearing bottoms.
884799
864241
884792
884793
8. Press a new inner bearing race onto the vertical
shaft. Use special tool 884793.
9. Press a new ball bearing onto the vertical shaft
special tool 884266.
NOTE! Install the bearing so that the thick part of the
inner race faces up.
10. Place the thin spacer pad (1) on the ball bearing
press on the roller bearing. Use special tool 884266.
Repair instructions
884266
884266
1
107