Volvo Penta AQUAMATIC 280 Workshop Manual page 138

885143
13. Pull down the retaining pawl and lift up the stern-
drive sufficiently to allow the installation of special
tool 885143 between the transom shield and the sus-
pension yoke.
Hang the hose clamp on to the cooling water hose and
connect the hose to the hose attachment on the
suspension yoke.
IMPORTANT! Turn the hose clamp so that the
tightening screw ends up at two o'clock on the
starboard side. This is important. Should the
hose clamp be installed incorrectly, this can
damage any of the other bellows.
14. Hang on the hose clamp for the exhaust bellows
and push it onto the neck of the sterndrive. Turn the
hose clamp into the position indicated by the picture.
See also point 15.
15. Check to make sure that all bellows and hoses
have been installed correctly and well tightened.
Tilt the sterndrive and turn it fully both ways and
check simultaneously that the tightening screws of
the bellows do not touch neither the sterndrive, the
transom shield nor the bellows. Adjust if necessary.
Use special tools 885143 and 884573.
The above picture reflects the correct positioning of
the hose clamps.
16. Center the cylinder attachment holes and the cyl-
inders. Grease the trim cylinder bolts and install
them.
Repair instructions
135