Volvo Penta AQUAMATIC 280 Workshop Manual page 116

884806
29. Press the needle bearing into the propeller shaft
with the text on the bearing turned facing the tool. Use
special tool 884806. Press the tool until it bottoms.
NOTE! Do not install the seal rings, wait until the gear
tooth clearance and contact pattern are checked.
30. Press the roller bearing onto the propeller shaft.
Use special tool 884801.
31. Press the inner needle bearing race onto the pro-
peller shaft. Use special tool 884801.
32. Apply marking dye on the convex side of the aft
gear. Place the calculated shims for the intermediate
bearing and the intermediate bearing on the inner pro-
peller shaft. Install special tool 885197 onto the
threads until the tool bottoms.
884798
33. Install special tool 884798 on the propeller shaft
with the washer and nut. Using a 30 mm wrench, tight-
en the nut until the intermediate bearing bottoms. Use
special tool 884830 or 3850598 and a wrench as a
counter hold on the vertical shaft. After the intermedi-
ate bearing is pressed on completely, remove the
special tools from the propeller shaft.
34. Coat the convex side of the aft gear with marking
dye. Insert the gear assembly onto the inner propel-
ler shaft.
Repair instructions
113