Volvo Penta AQUAMATIC 280 Workshop Manual page 79

Repair instructions
12. Press in both sealing rings. Use special tool
884259.
NOTE! The sealing rings are to seal against water
and thus have to be installed "facing" each other.
13. Glue the bushing to the yoke.
Use bushing installation adhesive, Volvo Penta part
no. 11161351-0 or Loctite
turned downwards against the retaining pawl.
76
® 603 . The flange must be
14. Install the retaining pawl in the yoke and place the
yoke with the retaining pawl in its location in the inter-
mediate housing.
NOTE! Insert the wear washer (1) between the lower
attachment of the yoke and the intermediate housing
and the two plastic washers (2) with one on each
side of the bearing. Then press in the steering spin-
dle until the collar bottoms. Be very careful during the
installation of the steering spindle in order to avoid
damaging the lower sealing ring.
15. Install the hose connection with its gasket on the
yoke. Coat the sealing surfaces with sealing
compound, Volvo Penta part no. 1161099-5 or
Permatex ® no. 3.
NOTE! On sterndrive model 280 the hose connection
must be pointing straight forwards.