Operating Instructions; Connections; High Pressure Hose; Water Connection - Alto 30CA COMPACT Instruction Manual

3.0 Operating instructions

3.1 Connections

1.

High pressure hose

The high pressure hose with imprinted max. working pressure and temperature should be attached to the
outlet socket (1) by the quick coupling (2).
2.

Water connection

Let water run through the inlet hose to remove any impurities. Clean all coupling parts of impurities.
Attach the inlet hose to the quick coupling of the water inlet (1).
The water supply system must supply min. 720 l/h (12 l/min.).
If there is a risk of impurities (i.e. running sand) in the inlet water, an external sand filter should be mounted
beyond the internal filter of the cleaner. Please contact your ALTO distributor for further information.
NOTE: Connection to the public mains according to regulations.
Pre-priming; see section 5.0.
Note for GB: Connection to the outside water tap must comply with Water Bye law 18, requiring the use of
a double check valve to prevent contaminated water being siphoned back into the mains.
For mounting instructions, please refer to the enclosed manual. Non compliance can result in heavy fines.
3.

Mains power connection

Only connect to an approved socket with earth connection.
Check voltage, fuse, cables and extension cables according to section 2.1.
6
Max. length of extension hose: 10 m.
Only use ALTO high pressure hose.
Important! Only use water without
impurities. The warranty does not cover
damages caused by impurities in the
inlet water.
Min. length of hose: 6 m. ½".
Clean water filter at monthly intervals.
Max. water pressure: 10 bar.
Only connect to an approved socket with
earth connection.
GB