Placement Of Accessories, Hose And Cable; Transport Directions - Transport Handle; Storage - Alto 30CA COMPACT Instruction Manual

3.6 Placement of accessories, hose and cable

Place the spray lance in the support for spray lance (1), nozzle facing upwards. Wind up the electric cable
and place it on the transport handle (2). Then wind up the high pressure hose and place it on the electric
cable.

3.7 Transport directions - transport handle

The machine has a transport handle (1) and wheels so that it is easy to transport.
The transport handle can be pushed up and down according to requirements. Press the release (2) and
pull up the handle until you hear a click when the handle is in top position. By pressing the release (2) the
handle can be pushed down again.
When lifting the machine manually lift it by the handle (3) when folded up and, if necessary, under the front
edge of the bottom (4). When lifting by crane lift it by the lifting handle (3) - use a lifting strap.

3.8 Storage

Prior to storing, the pump, hose and accessories should be completely emptied of water as follows:
1. Stop the machine and detach the water inlet hose and any accessory.
2. Restart the machine and activate the spray handle.
Let the machine run until all water has run out of the spray handle.
3. Stop the machine and detach the high pressure hose.
FROST PROTECTION: If the store room is not frost-free the machine should be protected with an anti-
freeze solution, and hoses and accessories should be emptied of water.
Operating instructions
Spray lance in support for spray lance (1)
Electric cable and high pressure hose on
the handle (2)
Container in support for container (3).
Lifting points: handle (3) and under the
front edge of the bottom (4).
Frost-free room!
Empty pump, hose and accessories of
water prior to storing.
GB
9