Operating Instructions; Accessories; End Of Operation - Alto COMPACT 1050 X-TRA Instruction Manual

2.0 Operating Instructions

2.1 Operating facilities
Start/stop switch (1).
Spray handle with safety catch (5).
2.2 Connection
1. Attach the high pressure hose (4) to the high
pressure water outlet of the machine (2).
2. Attach the spray handle (5) to the high pressure
hose (4). Prior to operating the machine please
ensure that the high pressure hose has been
completely uncoiled. Whilst the machine is in
operation the hose MUST NOT loop.
3. Mount the nozzle or any other equipment you
want to use.
4. Connect the machine to the water and power
supplies.
The pressure washer is now ready for operation.
2.3 Start
1. Unlock the spray handle.
2. Activate the trigger and let the water run until all
air has escaped from hoses and pump.
3. Press the start/stop switch (1) into pos. "I".
2.4 Operation
1. The spray lance is affected by a thrust
during operation - therefore always hold
it fi rmly with both hands. NOTE: Point the
nozzle at the ground.
2. Activate the trigger of the spray handle.
3. Always adjust the distance and thus the pres-
sure of the nozzle to the surface which is to be
cleaned. (Note! pressure and spray angle can be
regulated on the nozzle).
NOTE: Do not cover the machine during operation.
If the machine is left or not used for 3 minutes, it
must be switched off on the start/stop switch (1)
(press the switch into pos "O").
Secure the spray handle against inadvertent use by
locking the trigger with the safety catch.
12
Operating Instructions

2.5 End of operation

1. Stop the machine by pressing the start/stop
switch (1) into pos. "O".
2. Disconnect the plug from the socket.
3. Shut off the water supply and ac ti vate the trigger
to relieve the machine of pres sure.
Concerning storage, please refer to section 5.0.

3.0 Accessories

Only use original accessories.
3.1 POWERSPEED
The pressure washer is supplied with a
POWERSPEED ® nozzle (8). This nozzle has a pen-
cil jet which rotates through 360° when in use. This
gives increased performance for removing diffi cult
and stubborn marks. To fi t the POWERSPEED
nozzle, proceed as follows:
1. Push the POWERSPEED
bayonet coupling of the spray handle (5) and twist
in a clockwise direction until it clicks into place.
3.2 Foam sprayer
To fi t the foam sprayer (9), proceed as follows:
1. Push the foam sprayer (9) into the bayonet
coupling of the spray handle (5) and twist in a
clockwise direction until it clicks into place. En-
sure that the clear plastic pipe is fi tted to the foam
sprayer.
2. Fill the bottle with a suit a ble biodegradable de-
ter gent.
3. Screw the bottle onto the foam sprayer.
Extra equipment
Multispeed ® nozzle Universal adjustable nozzle:
nozzle
®
®
nozzle (8) into the
Nozzle forward: Low pres su re.
Nozzle backward:
High pressure.
Nozzle turned left:
20° spray angle.
Nozzle turned right:
No spray angle (pencil jet).
EN
EN
®