Operating Instructions - Alto Triton 730 Operating Instructions Manual

2.0 Operating Instructions

2.1 Operating facilities (fig. A)
1 Water connection
2 High pressure outlet
3 Cleaning agent metering unit
4 Pressure/volume regulator
5 Pressure gauge
6 Cleaning agent tank
7 Trigger with lock
8 Spray lance with pressure regulation
9 Nozzles
10 High-pressure hose
11 On/Off switch
2.2 Connection
1. Attach the high pressure hose to the high
pressure washer.
2. Mount the nozzle or any other equipment
you want to use (fig. B).
Note: When attaching to the snap connec-
tor, the pawl on the side of the connector
should come out again. Press the pawl to
detach the equipment.
3. Connect the machine to the water and
power supplies.
2.3 Start
1. Activate trigger and let the water run out
until any air has escaped from the inlet
hose (fig. C).
2. Turn the On/Off switch (fig. D) into pos. 1
(fig. D).
2.4 Operation
1. The spray lance is affected by a
recoil force during operation -
therefore always hold it firmly with both
hands.
2. Select high or low pressure (fig. E):
Turn pressure reducing valve
- clockwise = high pressure
- conterclockwise
= low pressure
= addition of detergents (fig. F)
3. Activate the trigger of the spray handle
(fig. C).
4. Always adjust the distance and thus the
pressure of the nozzle to the surface which
is to be cleaned.
14
NOTE: Do not cover the machine during op-
eration.
Suction mode(fig. G)
1.Before using the cleaner in suction mode,
first connect the cleaner to the water tap via
the water hose and switch on briefly.
This is important in order to avoid dry run-
ning during suction operation.
2.Unscrew the water hose.
3.Remove the tap connection or hose adapter.
4.Screw the suction set directly to the water
connection and fill the hose with water via
the suction screen. Hang the other end of
the suction hose into the water reservoir.
NOTE: The internal filter of the machine is not
intended for the filtration of large quantities of
impurities. If the water contains leaves, sand
or the like, an external suction filter should be
mounted. For further information, please con-
tact your nearest ALTO distributor.
2.5 End of operation
1.Stop the machine by turning the start/stop
switch into pos. 0.
2. Close the metering valve (fig. F)
3. Turn off the water tap
4. Activate the trigger (fig. F) to relieve the
machine of pressure.
5. Insert the trigger lock (fig. H)
6. Disconnect the plug from the socket.
7. Disconnect the water hose from the cleaner
Concerning storage, please refer to section
6.0.
GB