Yamaha FJR1300AS(X) Service Manual page 97

1. Right grip warmer lead
2. Brake hose (front brake master cylinder to brake
pipe/lower joint assembly)
3. Right handlebar switch lead
4. Clutch hose
5. Left handlebar switch lead
6. Left grip warmer lead
7. Main switch lead
8. Immobilizer unit lead
9. Left horn (low)
10. Brake hose (brake pipe/upper joint assembly to left
front brake caliper)
11. Front wheel sensor lead
12. Brake hose (brake pipe/upper joint assembly to
right front brake caliper)
13. Brake hose (metering valve to right front brake
caliper)
14. Brake hose (brake pipe/upper joint assembly to
front brake calipers)
15. Right horn (high)
16. Headlight (on/off)/grip warmer relay
17. Radiator fan motor relay
18. Main fuse
19. Positive battery lead
20. ABS test coupler
21. Throttle cable (accelerator cable)
22. Throttle cable (decelerator cable)
A. Route the right handlebar switch lead and right
grip warmer lead under the handlebar.
B. Route the left handlebar switch lead and left grip
warmer lead under the handlebar.
C. Pass the clutch hose, right handlebar switch lead,
left handlebar switch lead, right grip warmer lead,
and left grip warmer lead through the guide.
D. Route the main switch lead to the inside of the
clutch hose.
E. Fasten the right handlebar switch lead, right grip
warmer lead, main switch lead, and immobilizer
unit lead with a plastic locking tie. Face the end of
the plastic locking tie downward, angled inward,
and then cut off the excess end of the tie.
F. Route the immobilizer unit lead to the inside of the
clutch hose.
G. Temporarily tighten the brake hose joint bolt, union
bolt, and brake hose holder bolt in the proper
tightening sequence as shown. Then, tighten the
bolts to the specified torques, making sure to
tighten the brake hose joint bolt "1" last.
H. To front cowling wire harness
I. Install the horn L-shaped connectors so that the
leads are routed outward.
J. Fasten the grommet on the front wheel sensor lead
with the holder.
K. Connect the coupler that has blue tape wrapped
around its leads to the radiator fan motor relay.
L. Install the ABS test coupler completely onto the
tab on the battery stay.
M. Pass the brake hose (front brake master cylinder to
brake pipe/lower joint assembly), right handlebar
switch lead, right grip warmer lead, and throttle
cables through the guide as shown in the
illustration.
CABLE ROUTING (FJR1300A)
N. Fasten the right grip warmer lead to the throttle
cables with a plastic locking tie 10 mm (0.39 in) or
less from the end of the throttle cable boot. Face
the end of the plastic locking tie upward or
downward, and then cut off the excess end of the
tie.
2-46