Yamaha FJR1300AS(X) Service Manual page 36

• The accuracy of the temperature reading may
be affected when riding slowly (approximately
under 20 km/h) or when stopped at traffic sig-
nals, railroad crossings, etc.
Instantaneous fuel consumption mode
1. Instantaneous fuel consumption
The instantaneous fuel consumption display can
be set to either "km/L" or "L/100 km".
• When the display is set to "km/L", the dis-
tance that can be traveled on 1.0 L of fuel un-
der the current riding conditions is shown.
• When the display is set to "L/100 km", the
amount of fuel necessary to travel 100 km un-
der the current riding conditions is shown.
NOTE:
• To switch between the two instantaneous fuel
consumption displays, push the "RESET" but-
ton for 1 second when either display is shown.
• If traveling at speeds under 10 km/h, "_ _._ "
will be displayed.
Average fuel consumption mode
1. Average fuel consumption
This display shows the average fuel consump-
tion since it was last reset.
The average fuel consumption display can be
set to either "AV _ _._ km/L" or "AV _ _._ L/100
km".
When the average fuel consumption mode is se-
lected, the display flashes for five seconds, and
then, depending on the unit set, "AV _ _._ km/L"
(average distance that can be traveled using 1.0
L of fuel) or "AV _ _._ L/100 km" (average
amount of fuel necessary to travel 100 km) is
displayed.
To reset the average fuel consumption display,
push the "RESET" button to select the mode
again, and then push the "RESET" button for 1
second while the display is flashing.
1.
NOTE:
• To switch between the two average fuel con-
sumption displays, push the "RESET" button
for 1 second when either display is shown.
• After resetting an average fuel consumption
display, "_ _._ " will be shown for that display
until the vehicle has traveled 1 km.
EC3P66002
CAUTION:
If there is a malfunction, "– –.–" will be dis-
played. Replace the meter assembly.
Ambient temperature, instantaneous fuel
consumption and average fuel consumption
modes (for the UK only)
1. Ambient temperature/instantaneous fuel
consumption/average fuel consumption
2. "SELECT" button
3. "RESET" button
Push the "RESET" button to switch the display
between the ambient temperature mode "Air",
the instantaneous fuel consumption mode
"MPG" and the average fuel consumption mode
"AV_ _._ MPG" in the following order:
Air → MPG → AV_ _._ MPG → Air
1-27
FEATURES