Yamaha FJR1300AS(X) Service Manual page 550

Fault
code Symptom
No.
Data from the ECU cannot
Er-3
be received correctly.
Non-registered data has
Er-4 been received from the
meter.
Sensor operation table
Diag-
nostic
code
No.
d:01 Throttle angle
• Fully closed position
• Fully opened position
d:03 Pressure difference
(atmospheric pressure and
intake air pressure)
d:05 Intake air temperature
d:06 Coolant temperature
d:07 Vehicle speed pulse
d:08 Lean angle sensor
• Upright
• Overturned
• Open or short circuit in front cowling wire
harness.
• Open or short circuit in wire harness.
• Malfunction in meter assembly.
• Malfunction in ECU.
• Open or short circuit in front cowling wire
harness.
• Open or short circuit in wire harness.
• Malfunction in meter assembly.
• Malfunction in ECU.
Item
15–17
97–100
Displays the intake air pres-
sure.
Displays the intake air tem-
perature.
Displays the coolant temper-
ature.
0–999
0.4–1.4
3.7–4.4
FUEL INJECTION SYSTEM
Probable cause of malfunction
Meter display
8-73
Diagnostic
code No.
—
—
Checking method
Check with throttle fully
closed.
Check with throttle fully
open.
Set the engine stop switch
to " ", and then push the
start switch " ". (If the dis-
play value changes, the
performance is OK.)
Compare the actually mea-
sured intake air tempera-
ture with the meter display
value. (*1)
Compare the actually mea-
sured coolant temperature
with the meter display val-
ue.
Check that the number in-
creases when the rear
wheel is rotated. The num-
ber is cumulative and does
not reset each time the
wheel is stopped.
Remove the lean angle
sensor and incline it more
than 65 degrees.