Yamaha FJR1300AS(X) Service Manual page 37

Ambient temperature mode
1. Ambient temperature
This display shows the ambient temperature
from -9 °C to 50 °C in 1 °C increments. The tem-
perature displayed may vary from the ambient
temperature.
1.
NOTE:
• If the ambient temperature falls below -9 °C, a
lower temperature than -9 °C will not be dis-
played.
• If the ambient temperature climbs above 50 °C,
a higher temperature than 50 °C will not be dis-
played.
• The accuracy of the temperature reading may
be affected when riding slowly [approximately
under 20 km/h (12.5 mi/h)] or when stopped at
traffic signals, railroad crossings, etc.
Instantaneous fuel consumption mode
1. Instantaneous fuel consumption mode
This display shows the distance that can be trav-
eled on 1.0 Imp.gal of fuel under the current
riding conditions.
1.
NOTE:
If traveling at speeds under 10 km/h (6.0 mi/h),
"_ _._" will be displayed.
Average fuel consumption mode
1. Average fuel consumption
This display shows the average fuel consump-
tion since it was last reset.
When the average fuel consumption mode is se-
lected, the display flashes for five seconds, and
then "AV _ _._ MPG" (average distance that can
be traveled using 1.0 Imp.gal of fuel) is dis-
played.
1.
NOTE:
• To reset the average fuel consumption display,
push the "RESET" button to select the mode
again, and then push the "RESET" button for 1
second while the display is flashing.
• After resetting the average fuel consumption
display, "_ _._" will be shown for that display
until the vehicle has traveled 1 km (0.6 mi).
ECA3P6D001
CAUTION:
If there is a malfunction, "– –.–" will be dis-
played. Replace the meter assembly.
Self-diagnosis device
1. Fault code display
2. Immobilizer system indicator light
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the engine
trouble warning light will come on, and then the
multi-function display will indicate a two-digit
fault code.
1-28
FEATURES