Hydraulic Unit Operation Tests - Yamaha FJR1300AS(X) Service Manual

Hide thumbs Also See for FJR1300AS(X):
Table of Contents

Advertisement

16.Delete the fault codes. (Refer to "[D-1] DE-
LETING THE FAULT CODES" on page
8-179.)
17.Perform a trial run. (Refer to "TRIAL RUN" on
page 4-69.)
EAS22800

HYDRAULIC UNIT OPERATION TESTS

The reaction-force pulsating action generated in
the brake lever and brake pedal when the ABS
is activated can be tested when the vehicle is
stopped.
The hydraulic unit operation can be tested using
the following two methods.
• Hydraulic unit operation test 1: this test checks
the function of the ABS after the system was
disassembled, adjusted, or serviced.
• Hydraulic unit operation test 2: this test gener-
ates the same reaction-force pulsating action
that is generated in the brake lever and brake
pedal when the ABS is activated.
Hydraulic unit operation test 1
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Two people are necessary to perform hydraulic
unit operation test 1.
1. Place the vehicle on the centerstand.
2. Turn the main switch to "OFF".
3. Remove:
• Front cowling right inner panel 1
Refer to "GENERAL CHASSIS" on page 4-1.
4. Check:
• Battery voltage
Lower than 12.8 V → Charge or replace the
battery.
Battery voltage
Higher than 12.8 V
NOTE:
• If the battery voltage is lower than 12.8 V,
charge the battery, and then perform hydraulic
unit operation test 1.
• If the battery voltage is lower than 10 V, the
ABS warning light comes on and the ABS does
not operate.
ABS (ANTI-LOCK BRAKE SYSTEM)
5. Connect the test coupler adapter "1" to the
ABS test coupler "2".
Test coupler adapter
90890-03149
2
6. Turn the main switch to "ON" while operating
the brake lever and the brake pedal simulta-
neously.
NOTE:
• This check cannot be performed unless both
the brake lever and the brake pedal are oper-
ated simultaneously when the main switch is
turned to "ON".
• Do not push the start switch when turning the
main switch to "ON", otherwise the operation
test will not begin.
7. Check:
• Hydraulic unit operation
4-66
1

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Fjr1300a(x)

Table of Contents