Konica Minolta bizhub C451 User Manual page 746

Utility mode
The Punch Regist Loop Size Adjustment screen appears.
6
Check the angle of the punched holes.
– If the punched holes are angled, touch [-] to change the adjustment.
If the angle cannot be adjusted by touching [-] or if the paper is
wrinkled, touch [+] to change the adjustment.
– Each time [+] or [-] is touched, the value is increased or decreased
by one increment.
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The angle of the punched holes is adjusted.
If no adjustment of the angle of the punched holes was necessary in
step 6, this completes the procedure.
8
Use a Punch setting to print another sample copy.
C451
Finisher FS-517/FS-608
Finisher FS-519
11
11-89