5.5
[Network Settings]
[Detail Settings]
To display: [Utility] - [Administrator Settings] - [Network Settings] - [Detail Settings]
Configure the detailed network settings.
Settings
[Device Setting]
[Network Speed]
[SLP Setting]
[IEEE802.1x Authentication Settings]
To display: [Utility] - [Administrator Settings] - [Network Settings] - [IEEE802.1x Authentication Settings]
Select whether or not to use IEEE802.1X authentication.
To configure the IEEE802.1X detailed setting, use Web Connection. For details, refer to Chapter 1 "Using
Web Connection" in [User's Guide: Applied Functions].
[Disable] is specified by default.
[Internet ISW Settings]
To display: [Utility] - [Administrator Settings] - [Network Settings] - [Internet ISW Settings]
Configure the settings to externally download the machine firmware and update it.
For details, contact your service representative.
[AirPrint Setting]
To display: [Utility] - [Administrator Settings] - [Network Settings] - [AirPrint Setting]
Configure settings to print data from an AirPrint-compatible terminal.
Settings
[AirPrint Setting]
[Connect. Timeout]
Tips
If one of the following functions is disabled after the AirPrint function has been enabled, the AirPrint function
is also disabled synchronously.
-
[Utility] - [Administrator Settings] - [Network Settings] - [HTTP Server Settings] - [HTTP Server Settings]
-
[Utility] - [Administrator Settings] - [Network Settings] - [HTTP Server Settings] - [IPP Settings]
-
[Utility] - [Administrator Settings] - [Network Settings] - [Bonjour Settings]
-
[Network] - [IPP Settings] - [Accept IPP Job] in the administrator mode of Web Connection
[Description of Utility Keys]
Description
Specify the network speed.
Select the network speed according to your environment. Selecting [Auto] en-
ables communication in all network environments.
[100Mbps Half Duplex] is specified by default.
Select whether or not to enable SLP (Service Location Protocol).
[Enable] is specified by default.
Description
Select whether or not to use AirPrint.
To receive an AirPrint print job, select [Enable].
[Disable] is specified by default.
Enter the timeout for communications.
[60 sec.] is specified by default.
5
5-15