Change Confirmation/Adjustment Progress Messages; Setting The Marker Display - Sony PDW-850 Operation Manual

Change confirmation/adjustment
progress messages
You can limit or suppress the messages that give
details of setting changes and adjustment
progress and results by setting a display mode.
The conditions under which messages are
displayed and their correspondence with the
display mode are as follows:
Y: Message is displayed.
N: Message is not displayed.
Message display Message
condition
When the filter FILTER: n (where
selection has been n = 1, 2, 3, 4)
changed
When the gain GAIN: n (where n
setting has been = –6dB, –3dB, 0dB,
changed 3dB, 6dB, 9dB,
12dB, 18dB, 24dB,
30dB, 36dB, 42dB)
When the setting of WHITE: n (where n
the WHITE BAL = A CH, B CH,
switch has been PRESET) or ATW:
changed RUN
When the DCC: ON (or OFF) N Y Y
OUTPUT/DCC
switch has been set
to DCC ON or OFF
When the shutter :SHUTTER:
speed and mode 1/100 (or 1/125,
setting has been 1/250, 1/500,
a) 1/1000, 1/2000,
changed
ECS)
When the black or E.g. AWB : OK
white balance has
been adjusted
a) This is also displayed for about 3 seconds when the
SHUTTER selector is set to ON.
Changing the display mode
1
Display the VF DISP 1 page of the
OPERATION menu, and press the
MENU knob.
For details on menu operations, see "Basic
menu operations" (page 193).
Display
mode
setting
1 2 3
N N Y
N N Y
N N Y
N Y Y
N Y Y
Setting the Status Display on the Viewfinder Screen and the LCD Monitor
2
Select VF DISP MODE, and press the
MENU knob.
3
Select the desired display mode, and
press the MENU knob.

Setting the marker display

Switch the display of the center and safety zone
markers on or off, and select whether the area
indicated by the safety zone marker is 80%, 90%,
92.5%, or 95% of the screen area.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1
Display the MARKER 1 or MARKER 2
page of the OPERATION menu, and
press the MENU knob.
For details on menu operations, see "Basic
menu operations" (page 193).
2
Select the desired item, and press the
MENU knob.
You can set the following items on the
MARKER 1 and MARKER 2 pages.
MARKER 1 page
Item Description
MARKER To hide all markers, set to
"OFF".
CENTER To display the center marker,
set to "ON".
CENTER Selects the display mode of the
MARK center marker.
SAFETY To display the safety zone, set
ZONE to "ON".
SAFETY Selects the safety zone range
AREA (80%, 90%, 92.5% or 95%).
ASPECT To display the aspect marker,
set to "ON".
ASPECT Selects the aspect mode (15:9/
SELECT 14:9/13:9/4:3/1.85/2.35).
ASPECT To make the areas out of the
MASK selected aspect marker dimmer,
set to "ON".
ASPECT To set the mask level, when the
MASK LVL ASPECT MASK is set to
"ON".
100% To display the effective pixel
a)
area, set to "ON".
MARKER
a) 100% MARKER is disabled when the focus
assist indicator is displayed.
203