Sony PDW-850 Operation Manual page 250

Warning
indication
—
Problem
Internal drive sensor error
a) Asterisks (*) are replaced by digits in the display.
b) During recording
c) During playback, fast forward, fast reverse, or stop
d) During recording pause
e) During recording or pause
f) 1 flash/s
g) 4 flashes/s
h) During recording, displayed in the LCD monitor only
(When the DISP SEL/EXPAND button is set to
STATUS)
i) During recording and recording pause, displayed in
the LCD monitor only (When the DISP SEL/
EXPAND button is set to STATUS)
j) When TL-RE (3-layer) disc is inserted
k) When QL-R (4-layer) disc is inserted
For details about the warning displays and alarm
messages on the viewfinder, see the next item.
Operation/alarm messages
Operation and alarm messages are displayed in
the operation/alarm message display area (see
page 31) of the viewfinder screen.
AUTO The unit is operating in Auto
INTERVAL Interval Rec mode (**M**S:
**M**S Indicates the shooting interval in
minutes and seconds).
MANU The unit is operating in the single-
INTERVAL shot mode of Manual Interval Rec
*FRAME mode (*FRAME: Indicates the
number of frames recorded in one
shot).
INTERVAL The unit is operating in the
**S (M/H) consecutive mode of Manual
*FRAME Interval Rec mode (**S (M/H):
Indicates the trigger interval, in
seconds (minutes or hours),
*FRAME: Indicates the number
of frames recorded in one shot).
LOW LIGHT Depending on the setting, the
subject illumination is inadequate.
250 Operation Warnings
State WARNING
indicator
—
VDR operation
Operation continues.
Warning sound REC/TALLY
Action to take
Protect the unit from shocks
and vibrations, turn off the
power, and contact a Sony
service representative.
ON-BOARD The backup battery of the internal
BATTERY
clock is empty.
EMPTY
DCP If this message continues to
EEPROM appear even after the unit is
DATA NG! powered off and on again several
DR EEPROM times, then the factory adjustment
DATA NG! data is invalid. Contact a Sony
DCP/DR service representative.
EEPROM
DATA NG!
a) Contact a Sony service representative to replace the
battery.
VDR operation messages are displayed in the
setting change and adjustment progress message
display area of the viewfinder screen (see
page 31). Take the actions listed in the following
table.
ILL. Disc! A disc that cannot be used by this
unit was inserted. Insert another
Professional Disc.
ILL. Index! Index file or file system error.
No FS! Exchange or format the disc.
Unknown FS!
No Support! A recorded clip cannot be handled
by this unit. Exchange or format
the disc.
FORMAT The disc could not be formatted
NG! automatically. Exchange the disc.
Disc Damage A disc that cannot be recorded was
inserted. To record, exchange the
disc.
Non AV Full The disc is full. Exchange or
MAX # Files format the disc.
Over DUR!
DI read err The disc was not recognized. Try
Read err ejecting the disc and inserting it
DRV ADJ err again. Or exchange the disc.
BATT
—
a)