Sony PDW-850 Operation Manual page 59

memory corresponding to the setting (A or B) that
is currently selected with the WHITE BAL
1)
switch.
You can then turn ATW off and continue
shooting with the current white balance values.
The unit continues to use the values that were in
effect immediately before ATW was turned off.
1) This function is not available when the WHITE BAL
switch is set to PRST. If you have connected a remote
control unit, the unit uses the memory corresponding
to the remote control unit setting (A, B, or C).
WB
ATW HOLD MEMORY: OFF
ATW: ON
a) White balance settings stored in memory
A, B, or C
WB
ATW HOLD MEMORY: ON
ATW: ON
b) White balance settings immediately
before ATW was turned off.
White balance settings used when ATW is turned
off
(WB: White balance setting value, t: Shooting
time)
If a memory error occurs
If the error message ": STORED DATA : NG"
flashes on the viewfinder screen when the
camcorder is turned on, the white balance and
black balance memory contents have been lost.
Adjust the white balance and black balance again.
Contact a Sony representative if this message
a)
t
ATW: OFF
b)
t
ATW: OFF
Adjusting the Black Balance and the White Balance
continues to appear even after the white balance
and black balance have been adjusted again.
For details, refer to the Maintenance Manual.
59