Change Confirmation/Adjustment Progress Messages; Setting The Marker Display - Sony PDW-700 Operation Manual

VOLT: The voltage (VOLT) is displayed
continuously.
VF DISP 3 page
Item
LOW LIGHT
LOW LIGHT LEVEL Sets the LOW LIGHT
VF BATT WARNING Specifies the
3
Turn the MENU knob to select the
desired setting (ON, OFF, or value), and
press the MENU knob.
4
Repeat steps 2 and 3 until you have set
all of the desired items.
Change confirmation/adjustment
progress messages
You can limit or suppress the messages that give
details of setting changes and adjustment
progress and results by setting a display mode.
The conditions under which messages are
displayed and their correspondence with the
display mode are as follows:
Y: Message is displayed.
N: Message is not displayed.
Message display
condition
When the filter
selection has
been changed
When the gain
setting has been
changed
142 Setting the Status Display on the Viewfinder Screen and the LCD Monitor
Description
Turns on and off the
on-screen warning
that the average level
of the video has
dropped beneath a set
level.
threshold value.
remaining battery
capacity level that
starts the flashing
warning in the
viewfinder.
Message Display
mode
setting
1 2
ND: n (where n = N N
1, 2, 3, 4)
GAIN: n (where N N
n = –6dB, –3dB,
0dB, 3dB, 6dB,
9dB,12dB, 18dB,
24dB, 30dB,
36dB, 42dB)
Message display
condition
When the setting
of the WHITE
BAL switch has
been changed
When the
OUTPUT/DCC
selector has been
set to DCC ON
or OFF
When the shutter
speed and mode
setting has been
a)
changed
When the black
or white balance
has been adjusted
a) This is also displayed for about 3 seconds when the
SHUTTER selector is set to ON.
Changing the display mode
1
Display the VF DISP 1 page of the
OPERATION menu on the screen, and
press the MENU knob.
For details on menu operations, see "Basic
menu operations" (page 134).
2
Select VF DISP MODE, and press the
MENU knob.
3
Select the desired display mode, and
press the MENU knob.

Setting the marker display

Switch the display of the center and safety zone
3
markers on or off, and select whether the area
Y
indicated by the safety zone marker is 80%, 90%,
92.5%, or 95% of the screen area.
(How to select an item in the menu screen: Turn
Y
the MENU knob to move b to the desired item.)
1
Display the MARKER 1 or MARKER 2
page of the OPERATION menu on the
screen, and press the MENU knob.
Message Display
mode
setting
1 2
WHITE: n N N
(where n = A
CH, B CH,
PRESET) or
ATW: RUN
DCC: ON (or N Y
OFF)
:SS: 1/100 N Y
(or 1/125, 1/250,
1/500, 1/1000,
1/2000, ECS,
SLS)
E.g. WHITE : N Y
OK
3
Y
Y
Y
Y