Konica Minolta bizhub PRO C6501 User Manual page 64

3
4
Load the desired size of paper to be adjusted on a tray, touch Staple
and then press [Start].
A sample pattern will be output.
5
Open the Finisher door, and with-
draw the Staple unit.
– Confirm the distance between
the fixed plates and output pa-
per.
– When selecting the paper which
length side is 239mm or longer,
the Staple unit can not be
withdrawn.
– Remove output paper from the paper exit side, withdraw the staple
unit, and then reset the output paper in the unit.
6
Check whether any misalignment or paper buckling has occurred.
Misalignment may occur if the paper width setting is larger than the
actual width, and paper may become buckled if the paper width setting
is smaller than the actual width.
7
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Paper Width (Straight) Screen will be restored.
3-28
a
b
Adjustment
bizhub PRO C6501