Konica Minolta bizhub PRO C6501 User Manual page 152

3
5
Load the desired size of paper on the tray to be adjusted, specify
Punch, then press [Start] on the control panel.
A sample pattern will be output.
6
Check whether or not the punch position is skew on the output sheet.
7
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Registration Adjustment Screen will be restored.
8
Touch [+ <--> -] to specify the value to be positive or negative. Use the
touch panel keypad to enter the desired adjustment value, then touch
[<<SET].
Available range: -50 (wide) to +50 (narrow), 1 step = 0.1 mm
9
Repeat the adjustment steps from 3 to 8 until the desired result is
obtained.
10
If adjustment in any other size is required, repeat steps from 3 to 9.
11
Touch [Return] to restore the Adjustment Menu Screen.
3-116
Adjustment
bizhub PRO C6501