Lldp Check-Change-Interval; Lldp Enable - HP 5900 series Command Reference Manual

Parameters
txrx: Specifies the TxRx mode. A port in this mode can send and receive LLDPDUs.
Examples
# Configure the operating mode for the LLDP nearest non-TPMR bridge as TxRx on Ten-GigabitEthernet
1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp agent nearest-nontpmr admin-status txrx

lldp check-change-interval

Use lldp check-change-interval to enable LLDP polling and set the polling interval.
Use undo lldp check-change-interval to disable LLDP polling.
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
Default
LLDP polling is disabled.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Examples
# Enable LLDP polling on Ten-GigabitEthernet 1/0/1 and set the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp check-change-interval 30

lldp enable

Use lldp enable to enable LLDP on a port.
Use undo lldp enable to disable LLDP on a port.
Syntax
lldp enable
undo lldp enable
Default
LLDP is enabled on a port.
185