HP 5900 series Command Reference Manual page 14

Last clearing of counters: Never
Peak value of input: 0 bytes/sec, at 2011-01-01 22:10:43
Peak value of output: 0 bytes/sec, at 2011-01-01 22:10:43
Last 300 seconds input:
Last 300 seconds output:
Input (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 3 Command output
Field
Ten-GigabitEthernet 1/0/1 current state
IP Packet Frame Type
Unknown-speed mode
unknown-duplex mode
Link speed type is autonegotiation
Link speed type is force link
link duplex type is autonegotiation
link duplex type is force link
The Maximum Frame Length
0 packets/sec 0 bytes/sec -%
0 packets/sec 0 bytes/sec -%
Description
The state of the Ethernet interface:
•
Administratively DOWN—The Ethernet interface was shut down
with the shutdown command. The interface is administratively
down.
•
DOWN—The Ethernet interface is administratively up but
physically down (possibly because no physical link is present or
the link has failed).
•
UP—The Ethernet interface is both administratively and
physically up.
Ethernet frame format. The value PKTFMT_ETHNT_2 indicates that
the Ethernet frame format is Ethernet II.
Indicate that the rate of the interface is unknown. The reason may
be that the speed negotiation fails or the physical interface is
disconnected.
Indicate that the duplex mode of the interface is unknown. The
reason may be that the duplex mode negotiation fails or the
physical interface is disconnected.
The interface will negotiate a speed with its peer.
The speed of the interface is configured as a specific value, for
example, 1000 Mbps.
The interface will negotiate a duplex mode with its peer.
The interface is configured to operate in a specific duplex mode, for
example, full duplex mode.
The maximum Ethernet frame length allowed on the interface.
7