Stp Pathcost-Standard - HP 5900 series Command Reference Manual

Syntax
stp no-agreement-check
undo stp no-agreement-check
Default
No Agreement Check is disabled.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only after you enable it on the root port.
When the setting is configured in Ethernet interface view, it takes effect on only that interface.
When the setting is configured in aggregate interface view, it takes effect on only the aggregate
interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Enable No Agreement Check on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] stp no-agreement-check

stp pathcost-standard

Use stp pathcost-standard to specify a standard for the device to use when calculating the default path
costs for ports.
Use undo stp pathcost-standard to restore the default.
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
Default
The devices uses the legacy standard to calculate the default path costs for ports.
Views
System view
Predefined user roles
network-admin
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE
802.1d- 1 998.
121