Real Time Clock Mode - Fire-Lite 411UD Manual

Real Time Clock Mode

2. Press the [ENTER/STORE] key. The display will read LinP indicating that a valid password
is required to continue.
3. For the initial power-up of the 411UDAC or for the first power-up after a manually defaulted
password, key in the default password 0000 and press [ENTER/STORE]. The display will
then read dC_P.
4. Press d to continue with the default password or press C to change to a new password.
5. If d is entered in step 4, the display goes directly to the programming/default modes.
6. If C is entered in step 4, the display will read En_P prompting for a new password.
• Key in a new 4-digit password. Valid passwords are any four digit code from 0001-9999.
• The display will then read rEnP. Key in the new password again for verification.
• Once the new password has been verified, the programming/default modes will be accessed.
If at any time a password was entered incorrectly, the display will read AErr indicating an invalid
entry was made.
3.3 Real Time Clock Mode
Real Time Clock Mode is entered by pressing the MODE key followed by the 4-digit entry code
2525 and pressing the [ENTER/STORE] key. Accessing this mode requires authentication. Refer
to Section 3.2.
• 2525 spells CLCK on a Touch-Tone
If an incorrect key is entered, reenter the proper 4-digit code before pressing the [ENTER/STORE]
key. Note that as information is entered into the 411/411UD, the digits will scroll across the Pro-
grammer display from right to left.
A pause of up to 10 seconds between each number is allowed while entering the code. After press-
ing the [ENTER/STORE] key, the digital communicator will be in Real Time Clock Mode. A
maximum of 10 minutes idle time is allowed at this point before beginning program entries and
between each key stroke, otherwise, the digital communicator will return to Normal Mode. Note
that the time is not stored until the fourth and final digit is selected and the [ENTER/STORE] key
is pressed. If the 411/411UD returns to Normal Mode prior to entering the fourth digit, no changes
will be stored and the original time is retained.
On entering Real Time Clock Mode, 0.001 will appear on the Programmer display:
Digit to be programmed
The time is displayed in military time. Note the position of the decimal point in the display. This
indicates that the first digit to be programmed is the one to the left of the decimal point. To pro-
gram the first hour digit, press the corresponding number on the Programmer keypad and then press
the [ENTER/STORE] key. For example, to program 2:00 PM (1400 in military time), press '1' on
411 & 411UD Manual — P/N LS10105-000GE-E:A 1/29/2014
___2
__25
_252
2525
0.001
® phone.
Modes of Operation
25